Lubricant formulated from state-of-the-art mineral oils and additives for metal machining.
AMPAC 301 TURNING-MILLING
The refined mineral oils and the latest generation additives will ensure a good detachment of the machined chips, protect the tool and provide a better finished surface.
- Less loss of the same through the chip and the machined part saving lubricant .
- Low evaporation to minimize its presence in the environment .
- Maximum lubrication and cooling of the part and tool .
TEST
METHOD REF. ASTM
UNIT
VALUES
Density @ 15 ºC
D-287
Grs / cm3
0.880
Viscosity @ 40 ºC
D-445
cSt
30.3
Behavior against copper
-
-
Staining
4 EP balls at 620 kgf
D-2783
-
Pass (do not weld)
Imprint diameter
mm
1.7
Sulfur content
D-4951
% P / P
2.1
Chlorine content
-
% P / P
0
Phosphorus content
D-4951
ppm
256
Fat content
-
% P / P
0
200 and 100 liter drums, 20 liter bucket.
All containers must be stored under cover. In case of being stored outside the drums must be in
vertical position to avoid the possible entry of water as well as the deterioration of the container. Products must not be
stored at temperatures above 60º C, exposed to strong sun or low temperatures.